How to clean the chamber filter press?

In the process of using the chamber filter press, there will be a lot of dirt inside the chamber filter press, so how to clean the dirt of the chamber filter press.

In the process of using the chamber filter press, after long-term use, there will be a lot of contamination inside the chamber filter press, so how to clean the contamination of the chamber filter press is what we often do, then, the following Let's take a look at the cleaning of the lower chamber filter press.

The cleaning of the chamber filter press is mainly the cleaning of the bearing. The cleaning of the bearing is divided into rough washing and fine washing, and a metal mesh frame can be placed at the bottom of the container in use. During rough cleaning of the chamber filter press, use a brush, etc. to remove grease or sticking matter in the oil. At this time, if the bearing is rotated in oil, be careful that the rolling surface may be damaged by foreign matter or the like. During fine cleaning, the bearings are slowly rotated in the oil, which must be done carefully.

chamber filter press

Generally, the cleaning agent used in the chamber filter press is neutral non-hydrous diesel or kerosene, and sometimes warm lye is also used as needed. No matter which cleaning agent you use, filter it frequently to keep it clean. After the van filter press is cleaned, the imported bearings should be coated with anti-rust oil or anti-rust grease immediately. In this way, the service life of our chamber filter press can be extended.

In the chamber filter press, if the hydraulic power system of the equipment cannot work normally, it will directly lead to the failure of the entire chamber filter press equipment to work normally. So how do we protect the hydraulic system of the chamber filter press equipment?

1. Check the components of the hydraulic system.

Therefore, we need to regularly clean and inspect the hydraulic system. During the cleaning, we pay attention to observe the links of each part to see if there are signs of leakage. Once found, make up for it, so as not to cause greater damage to the equipment system. destroy.

2. The hydraulic oil needs to be replaced regularly. The hydraulic oil moves cyclically in the whole system, and often the hydraulic oil is under the action of strong pressure, and its impact force is relatively strong, so the hydraulic oil is in the process of moving.

We have been using the chamber filter press equipment for a period of time, and we need to replace the hydraulic oil to ensure the clarity of the hydraulic oil, which is also an effective protection for the hydraulic system.

3. Ensure the supply pressure range of the hydraulic system. In fact, the hydraulic system can change the power range. In fact, in order to protect it, we try to reduce the number of changes to it.

The above is the relevant knowledge about the cleaning of the chamber filter press. As a supplier of chamber filter press, Kintep specializes in selling filter press equipment. Our products are of good quality. If you want to know more about chamber filter press, then come and pay attention to our website. 

 


Jiangsu kintep

26 Blog posts

Comments