The main component of this equipment is that the bottom diameter of the screw increases gradually along the outlet direction of the slag and the pitch of the screw gradually decreases. When the material is pushed by the screw, due to the reduction of the volume of the screw cavity, the material is pressed.To get more news about Spiral juicing machine, you can visit hl-juicer.com official website.

Working principle of spiral juicer
The raw materials are fed into the feed hopper and pressed under the propulsion of the screw. The squeezed juice flows into the juice receiver at the bottom through the filter, and the waste material is discharged through the annular gap formed between the spiral and the pressure-adjusting conical part. The axial movement of the pressure regulating head can adjust the size of the gap. Used for clockwise (when looking at the slag trough of the equipment toward the hopper end, when the bearing is turned when the handwheel shaft is turned, the pressure head is to the left, the gap is reduced, otherwise the gap becomes larger.) Change the size of the gap, that is, adjust the row Slag resistance. The slag output rate can be changed, but if the gap is too small, part of the slag particles will be squeezed out with the juice through the filter under strong squeezing. Although the juice output increases, the quality of the juice relatively decreases, and the size of the gap should be considered The user's specific process requirements.

Spiral juicer application
This machine is suitable for squeezing the fruit juice of pineapple, apple, pear and other fruits and vegetables after crushing. Pushed by the screw shaft, it has the functions of crushing, juice extraction and slag discharge.

Maintenance of spiral juicer
The main component of this equipment is that the bottom diameter of the screw increases gradually along the outlet direction of the slag and the pitch of the screw gradually decreases. When the material is pushed by the screw, due to the reduction of the volume of the screw cavity, the material is pressed. The direction of rotation of the screw spindle is seen from the feed hopper toward the slag tank, which is clockwise.

Maintenance of spiral juicer
1. The cleaning of the appearance is relatively simple, just wipe it with a rag. Remember not to rinse with water or scrape with a hard object to avoid surface damage. The base should not be immersed in water to avoid damage to the insulation of the motor
2. The cutter head can be disassembled if possible, but the frequency should not be too frequent. The cutter head is likely to be entangled with fruits or other food fibers or residues. The residue should be pulled out in the direction of the winding first, and then rinsed with water.
3. Don't discard the small brushes or toothbrushes at home. They have special effects when cleaning small places, so the cleaning effect is better.
4. If the knife head is used to grind the meat, break the remaining buns into bun residue and put it into a blender to stir, which can effectively absorb the minced meat, etc., and it is cleaner to clean.
5. After squeezing the juice, disconnect the juicer from the power supply and separate the cup barrel from the host. First clean the machine briefly, don't let the pomace and other debris in the machine condense, this will cause some trouble to the next cleaning.